Alterações no passo nº 6
Edição por Curt Reitenbach —
Edição aprovada por Curt Reitenbach
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Connect red (positive) probe to the Voltage and Resistance Socket. |
|---|---|
| - | [* black] Connect black (negative) probe to the Common/Ground Socket. |
| - | [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting. |
| - | [* black] NOTE: Upon completing the steps above, the multimeter should read "OL" as shown in the picture. |
| - | [* black] NOTE: Verify the circuit board does not have any current supplied to it. |
| + | [* black] Setting up the multimeter: |
| + | [* black] Connect red (positive) probe to the Voltage and Resistance Socket. |
| + | [* black] Connect black (negative) probe to the Common/Ground Socket. |
| + | [* black] Turn knob of multimeter to the Diode and Capacitance Test Setting. |
| + | [* black] NOTE: Upon completing the steps above, the multimeter should read "OL" as shown in the picture. |
| + | [* black] NOTE: Verify the circuit board does not have any current supplied to it prior to performing next step. |
| + | [* black] Connect black probe to the circuit board where the solder bridge was. |
| + | [* black] Connect red probe to the circuit board above where the solder bridge was. |