Conserte seus objetos Comunidade Loja

Alterações no passo nº 4

Edição por Elizabeth Eckes —

Edição aprovada por Elizabeth Eckes

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Reapply solder to the contact point.
-[* black] Heat the solder on top of the contact point by pushing the soldering iron on the affected area.
+[* black] Apply soldering iron to the contact point.
+[* black] Once the contact point is hot, reapply the solder to the contact point.
[* icon_caution] The repaired area will be very hot! Avoiding touching the area being repaired.
-[* black] Continue applying the solder to the contact point until the circuit is complete.
+[* black] Continue applying the solder to the contact point until the pin is attached and the points seem both solidly attached and separate from each other.
[* icon_note] Step 7 verifies circuit continuity.