Alterações no passo nº 3
Linhas do passo
| [* black] Place the solder wick on top of the solder bridge and heat the wick using the soldering iron by pressing on top of the affected area. | |
| [* icon_caution] The solder wick will be very hot! Avoiding touching the area of the wick near the soldering iron. | |
| - | [* icon_note] Alternatively, use wire cutters to cut off about 2 cm (0.75") of braid. Use tweezers or needle nose pliers to place it as described above. |
| + | [* icon_note] Alternatively, use wire cutters to cut off about 2 cm (0.75") of braid. Use [product|IF145-020|tweezers] or needle nose pliers to place it as described above. |
| [* black] Continue to apply pressure with the soldering iron to the solder bridge until the solder is melted and absorbed by the wick. | |
| [* icon_note] A soldering flux can also be used here to aid in the desoldering process by reducing oxide films. |