Alterações no passo nº 3
Edição por Curt Reitenbach —
Edição aprovada por Curt Reitenbach
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] |
|---|---|
| + | [* black] Place the solder wick on top of the solder bridge and heat the wick using the soldering iron by pressing on top of the affected area. |
| [* icon_caution] The solder wick will be very hot! Avoiding touching the area of the wick near the soldering iron. | |
| - | [* black] Continue to apply the soldering iron to the solder bridge until the solder is melted and absorbed by the wick. |
| + | [* black] Continue to apply pressure with the soldering iron to the solder bridge until the solder is melted and absorbed by the wick. |
| [* icon_note] Soldering flux can also be used here to aid in the desoldering process by reducing oxide films. |