Alterações no passo nº 13
Edição por Clay Eickemeyer —
Edição aprovada por Clay Eickemeyer
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Hook the bottom edge of the charging coil connector cover onto its [link|https://guide-images.cdn.ifixit.com/igi/LRHFT2co6ECh1eub.huge|slots below the connectors|new_window=true] and align the cover with its screw post in the frame. |
|---|---|
| - | [* black] Use your tri-point Y000 driver to install the 1.0 mm screw. |
| + | [* black] Secure the charging coil connector cover using its slot or hook on the logic board. |
| + | [* icon_note] Refer to your specific phone's replacement guide for detailed instructions on this part. |
| + | [* black] Use your tri-point Y000 driver to install the screw and secure the cover. |