Alterações no passo nº 7
Edição por Joe Torres —
Edição aprovada por Joe Torres
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Re-attach pick guard |
|---|---|
| + | [* black] Re-attach the pickguard: Hold the pickguard in place on the guitar and align it properly. Make sure it sits flush against the body of the guitar and lines up with the screw holes. |
| + | [* black] Insert the screws: Insert the screws into the pickguard screw holes and lightly tighten them by hand. Make sure all the screws are in place and that the pickguard is firmly held in position. |
| + | [* black] Tighten the screws: Using a screwdriver, tighten the screws evenly, working in a criss-cross pattern from one corner of the pickguard to the opposite corner. This will ensure that the pickguard is tightened evenly and doesn't warp or bend. |
| + | [* black] Check for alignment: Once all the screws are tightened, check the alignment of the pickguard again. Make any necessary adjustments to ensure it is straight and even. |