Conserte seus objetos Comunidade Loja

Alterações no passo nº 3

Edição por Henry Peeples —

Edição aprovada por Henry Peeples

Antes
Depois
Sem alteração

Linhas do passo

-[* black] Gather your tools: You will need a screwdriver that fits the screws on your pickguard, and a small container or tray to hold the screws so you don't lose them.
-[* black] Loosen the screws: Use the screwdriver to loosen each screw on the pickguard. You don't need to remove the screws completely at this point, just loosen them enough so that they can be turned by hand.
-[* black] Remove knobs and pickup selector switch (If possible). I was not able to get them off in my case but later steps become much easier if they are removed.
+[* black] Loosen the screws: Use a screwdriver to loosen each screw on the pick-guard.
+[* black] Remove knobs and pickup selector switch.
+[* icon_note] These knobs can be very tough to remove. If you feel like you may damage them by forcing them off, just leave them on.