Alterações no passo nº 2
Edição por Sarah Westberg —
Edição aprovada por Sarah Westberg
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* red] Unscrew the 3 screws holding the battery and its housing. |
|---|---|
| - | [* black] Using the Philips screwdriver, twist counterclockwise to unscrew each 3mm silver screw. |
| - | [* black] Pull the battery housing with the battery out from the main board and set it aside. |
| + | [* red] Use a Phillips #000 to remove three 3.0 mm screws holding the battery and it's housing. |
| + | [* black] Remove the battery housing with the battery from the main board and set it aside. |
| + | [* icon_caution] At this point the battery is still attached to the motherboard by a connector so don't pull it off the board. |
| + | [* icon_note] If you're not replacing the battery, you can leave it attached to the board to complete the repair, just be careful when moving them so you don't damage the connection. |