Alterações no passo nº 3
Edição por Scott Larson —
Edição aprovada por Scott Larson
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Remove Graphics Card Pwr Connector & Screws | |
| - | [* black] Very carefully, use a 9in Needle-Nose Locking Pliers set to the lowest tension where enough grip will help you slowly and carefully rock the two power connectors gently up and down to pull the connectors out of there housings. Be careful not to rock the connector toward/away from you as that can break or bend the connections to the mainboard. |
| + | [* black] Use a spudger to slightly lift the connector hooks that are locking the power connectors in place and very carefully, use a 9in Needle-Nose Locking Pliers set to the lowest tension with enough grip to help you slowly and carefully rock the two power connectors gently up and down to pull the connectors out of their housings. |
| + | [* black] Be careful not to rock the connector toward/away from you as that can break or bend the connections to the mainboard. |
| [* black] Remove the top and bottom screws that are holding the graphics card in-place |