Alterações no passo nº 5
Edição por Aayma Mughal —
Edição aprovada por Aayma Mughal
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* icon_note] The power cable for this model does not utilize a ground wire. If the replacement cable contains ground wire, tape around the exposed wire using electrical tape. |
|---|---|
| + | [* black] Plug in and allow the soldering iron to heat up. |
| + | [* black] Using a wire stripper or pliers, remove approximately 0.5 inches of the plastic insulation around the hot and neutral wires. In this model, the hot wires are black and red and the neutral wire is white. |
| + | [* black] Feed the replacement cable through the entry point at the back of the unit. If it does not fit, the rubber insulation can be stripped using a utility knife. |
Imagem 1
Nenhuma imagem anterior
Adicionado