Alterações no passo nº 8
Edição por Sarah Westberg —
Edição aprovada por Sarah Westberg
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] There will be two screwed-in wires on either side of the machine. |
|---|---|
| - | [* red] Unscrew BOTH sets of wires from either side of the machine. They will both be 10mm screws. |
| - | [* black] You can remove these using a PH1 screw head. |
| - | [* black] One these screws are removed, the main body can be lifted off the base, and set aside. |
| + | [* red] Using a Phillips #1 screwdriver, remove one 10 mm screw from both sides of the machine. This will release wires that are screwed into the sides of device. |
| + | [* icon_note] Once the screws are removed and wires detached, the main body can be lifted off the base, and set aside. |