Alterações no passo nº 6
Edição por Chayton Ritter —
Edição aprovada por Chayton Ritter
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Insert an opening pick | |
| - | [* icon_note] If your display is badly cracked, [guide|140533|covering it with a layer of clear packing tape|new_window=true] may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken |
| - | [* black] Apply a suction handle to the right edge of the |
| - | [* black] Pull up on the suction cup with firm, constant pressure to create a small gap of about 2 mm |
| + | [* icon_note] If your display is badly cracked, [guide|140533|covering it with a layer of clear packing tape|new_window=true] may allow the suction cup to adhere. Alternatively, very strong tape may be used instead of the suction cup. If all else fails, you can superglue the suction cup to the broken display. |
| + | [* black] Apply a suction handle to the right edge of the display about 50 mm above the bottom edge. |
| + | [* black] Pull up on the suction cup with firm, constant pressure to create a small gap of about 2 mm between the display and the frame. |
| [* black] Insert the tip of an opening pick into the gap. | |
| [* icon_caution] Do not insert the opening pick more than 5 mm (0.2 in). |