Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #5

Edição por Sam Goldheart

Edição aprovada por Sam Goldheart

Antes
Depois
Sem alteração

Linhas de Passo

[* icon_reminder] When reassembling your device, attach the gasket to the heat sink as shown.
[*
icon_note] These shots show howThe tail of the rubber fan gasket should be installed during reassembly. Be sure not to installfit into the gasket underneath the ear wherenotch in the heat sink, it should not end ofup underneath the heatsink is screwed down toheat sink tab that will rest on the upper caselogic board.
[* icon_note] Additionally, beBe sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.
[* icon_reminder] When reassembling your device, attach the gasket to the heat sink as shown.
[*
icon_note] These shots show howThe tail of the rubber fan gasket should be installed during reassembly. Be sure not to installfit into the gasket underneath the ear wherenotch in the heat sink, it should not end ofup underneath the heatsink is screwed down toheat sink tab that will rest on the upper caselogic board.
[* icon_note] Additionally, beBe sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.