Ir para o conteúdo principal

Alterações no passo #3

Edição por Andrew Bookholt

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* icon_caution] Do not completely remove the LCD from the front bezel as the display data cable is still intertwined at the bottom of the front bezel.
-[* black] While holding the front bezel upright with one hand, slightly pull the LCD towards you and lay it on top of the front bezel.
+[* icon_caution] Do not try to remove the LCD yet. The circuitry along its lower edge is wedged in a gap along the lower edge of the display recess in the aluminum display assembly.
+[* black] Hold the display vertically and tip it enough to grab the top edge of the LCD and rotate it slightly out of the display assembly, being careful not to break the circuitry off its lower edge.
+[* black] Pull the LCD toward the top edge of the display to slide the circuitry along its lower edge out of the recess in the aluminum display assembly.
+[* icon_note] It may be helpful to use one hand to feed the display data cable through its channel in the aluminum display assembly as you pull the LCD toward the top edge of the display with the other hand.