Ir para o conteúdo principal

Alterações no passo #1

Edição por Andrew Bookholt

Aguardando aprovação

Antes
Depois
Sem alteração

Linhas de Passo

-[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black edge of the front glass panel to the display.
+[* icon_note] In the following steps, you will use a heat gun to soften the adhesive securing the outer black border around the underside of the front glass display panel.
[* black] With the heat gun set to low, start by heating the outer edge of the upper right corner of the glass panel.
[* icon_caution] Aim the heat gun away from the soft rubber strip around the display glass. Heating the rubber will cause it to melt slightly, turning its finish from matte to glossy. Throughout this process, avoid touching the rubber strip until it is sufficiently cooled.