Alterações no passo nº 8
Edição por Inah Embile —
Edição aprovada por Inah Embile
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* red] Using a Phillips #1 screwdriver, remove the 6-mm screw near the hard drive. |
|---|---|
| - | [* icon_note] This is not a captive screw and once loosened will be free to move about the assembly. Care should be take to not allow the fastener into the CPU fan and duct (located upper left). |
| + | [* red] Use a Phillips #1 screwdriver to remove the 6-mm screw near the hard drive. |
| + | [* icon_reminder] This is not a captive screw and, once loosened, will be free to move about the assembly. |
| + | [* icon_caution] Be careful not to allow either fastener into the CPU fan and duct (located in the upper left). |