Alterações no passo nº 3
Edição por Jeanette Lopez —
Edição aprovada por Jeanette Lopez
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* red] Using the Phillips #1 or Phillips #00 screwdriver, remove the two 3-mm screws from the card with black and white wires coming off of it. |
|---|---|
| + | [* icon_caution] Be careful not to allow any hardware into the CPU fan and duct, which is located in the upper left. |
| + | [* red] Remove the two 3-mm screws from the card equipped with black and white wires by using a Phillips #00 or Phillips #1 screwdriver. |
| [* icon_note] These are not captive panel screws and once loosened will be free to move about the assembly. | |
| - | [* icon_caution] Be careful not to allow either fastener into the CPU fan and duct (located in the upper left). |
| - | [* icon_note] The card should pop up. |
| [* orange] Gently remove the card with your fingers. |