Skip to main content

Alterações no passo #1

Edição por Jozsef

Edição recusada by Jake Devincenzi

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* icon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up.
[* icon_note] You need to remove the rubber base to get access to the screws.
[* black] Starting at one side of the device, use a hairdryerhair dryer or a heat gun to soften the adhesive holding the rubber base in place.
[* icon_caution] The rubber base will be hot after heating, take extreme care while proceeding.
[* black] Starting at one side of the device, use a hairdryerhair dryer or a heat gun to soften the adhesive holding the rubber base in place.
[* icon_caution] The rubber base will be hot after heating, take extreme care while proceeding.
[* black] While the adhesive is still warm, peel the bottom of the rubber base upwards to detach it from the metal plate.
[* black] Repeat the procedure described above until the rubber base has been completely removed.