Ir para o conteúdo principal

Alterações no passo #1

Edição por Walter Galan

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* blackicon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up.
[* blackicon_note] You need to remove the rubber base to get access to the screws.
[*

[*
black] Starting at one side of the device, use a hairdryer or low temperaturea heat gun to soften the adhesive holding the rubber base in place.
[*

[* icon_caution] The rubber base will be hot after heating, take extreme while proceeding.
[*
black] While the adhesive is still warm, pull up onpeel the lipbottom of the rubber base upwards to detach it from the metal plate.
[*

[*
black] Continue heating and pulling, slowly,Repeat the procedure described above until you have removed the entire pad.
[* black] Be careful,
rubber can get ripped easily!
[* icon_caution] The pad will be hot; take care not to burn your fingers!
base has been completely removed.
[* blackicon_reminder] Flip the Apple TV over so that the bottom of the unit is facing up.
[* blackicon_note] You need to remove the rubber base to get access to the screws.
[*

[*
black] Starting at one side of the device, use a hairdryer or low temperaturea heat gun to soften the adhesive holding the rubber base in place.
[*

[* icon_caution] The rubber base will be hot after heating, take extreme while proceeding.
[*
black] While the adhesive is still warm, pull up onpeel the lipbottom of the rubber base upwards to detach it from the metal plate.
[*

[*
black] Continue heating and pulling, slowly,Repeat the procedure described above until you have removed the entire pad.
[* black] Be careful,
rubber can get ripped easily!
[* icon_caution] The pad will be hot; take care not to burn your fingers!
base has been completely removed.