Skip to main content

Alterações no passo #1

Edição por Vasja

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Flip the Apple TV over so that the bottom of the unit is facing up.
[* black] You need to remove the rubber base to get access to the screws.
[* black] Starting at one side of the device, use a hairdryer or low temperature heat gun to soften the adhesive holding the rubber in place.
[* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate.
[* black] Continue heating and pulling, slowly, until you have removed the entire pad.
[* black] Be careful, rubber can get ripped easily!
[* icon_caution] The pad will be hot; take care not to burn your fingers!