Skip to main content

Alterações no passo #1

Edição por bushing

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] TurnFlip the Apple TvTV over so that the bottom of the unit is facing up.
[* black] You need to remove the rubber footingbase to get access to the screws. Carefully peeling
[* black] Starting at one side of
the rubber footing up is the only way to remove it. Usedevice, use a hairdryer or low temperature heat gun to loosensoften the glue tapeadhesive holding the rubber in place.
[* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate.
[* black] Continue heating and pulling, slowly, until you have removed the entire pad.
[* icon_caution] The pad will be hot; take care not to burn your fingers!
[* black] TurnFlip the Apple TvTV over so that the bottom of the unit is facing up.
[* black] You need to remove the rubber footingbase to get access to the screws. Carefully peeling
[* black] Starting at one side of
the rubber footing up is the only way to remove it. Usedevice, use a hairdryer or low temperature heat gun to loosensoften the glue tapeadhesive holding the rubber in place.
[* black] While the adhesive is still warm, pull up on the lip of the base to detach it from the metal plate.
[* black] Continue heating and pulling, slowly, until you have removed the entire pad.
[* icon_caution] The pad will be hot; take care not to burn your fingers!