Pular para o conteúdo principal

Alterações no passo #1

Edição por Walter Galan

Edição aprovada por Walter Galan

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* icon_note] You will be using an iOpener to transfer heat to the adhesive securing theThe home button assembly is attached to the front glass panel assemblywith some adhesive. The use of an iOpener to soften the adhesive is highly recommended.
[* black] ReheatPlace the iOpener in the microwave and microwave it for one minute'''one minute''' on the highest power setting.
[* black] Layicon_caution] Be careful not to overheat the iOpener flat onduring the front side, near the bottom edge of the front glass panel assembly, smoothing it out so that there is good contact between the surface of the front glass panel assembly andrepair procedure. We recommend waiting at least two minutes before reheating the iOpener.
[* black] LetPlace the bag sitiOpener over the home button on the front glass panel assembly for approximately 90 seconds before attempting to openedge of the front paneldisplay.
[* icon_note] You will be using an iOpener to transfer heat to the adhesive securing theThe home button assembly is attached to the front glass panel assemblywith some adhesive. The use of an iOpener to soften the adhesive is highly recommended.
[* black] ReheatPlace the iOpener in the microwave and microwave it for one minute'''one minute''' on the highest power setting.
[* black] Layicon_caution] Be careful not to overheat the iOpener flat onduring the front side, near the bottom edge of the front glass panel assembly, smoothing it out so that there is good contact between the surface of the front glass panel assembly andrepair procedure. We recommend waiting at least two minutes before reheating the iOpener.
[* black] LetPlace the bag sitiOpener over the home button on the front glass panel assembly for approximately 90 seconds before attempting to openedge of the front paneldisplay.