Alterações no passo nº 2
Edição por Spencer Pennington —
Edição aprovada por Spencer Pennington
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [* icon_caution] Do not bend the battery. Do not reuse the battery. |
|---|---|
| [* black] Apply a suction cup to the battery. | |
| [* icon_note] It may take multiple attempts to get the suction cup to adhere. Apply is as close to the center of the battery as possible and avoid the white sticker at the bottom of the battery. | |
| - | [* black] |
| + | [* black] Use firm, steady force to lift the battery straight up until there is a gap large enough to insert the opening pick. |
| [* black] Insert an opening pick underneath the bottom edge of the battery and twist to loosen the battery adhesive. | |
| [* icon_note] If the battery won’t pry out easily, apply a little more alcohol and repeat the last step to further weaken the adhesive. | |
| [* black] Remove the battery. | |
| - | [* |
| + | [* black] If you used isopropyl alcohol, wait ten minutes before installing the new battery to allow the alcohol to completely evaporate. |