Conserte seus objetos Comunidade Loja

Alterações no passo nº 7

Edição por Clay Eickemeyer —

Edição aprovada por Clay Eickemeyer

Antes
Depois
Sem alteração

Linhas do passo

+[* icon_caution] Be careful near the corners, as the glass is weakest there.
[* black] Insert an opening pick into the lower-left corner of the rear panel.
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel.
-[* icon_caution] Do not insert an opening pick in more than half way on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
-[* icon_note] It is fine if opening picks fall out as the back cover becomes separated. Remember, the corners are weakest so slow down, apply heat, work smart.
+[* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside.
+[* icon_note] It is fine if opening picks fall out as the back cover becomes separated.