Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #2

Edição por Katelyn Fry —

Edição aprovada por Katelyn Fry

Antes
Depois
Sem alteração

Linhas de Passo

[* icon_caution] Make sure to take care in prying case apart. There is aare two wires (one red wireand one black) that could get disconnected from the motherboard.
[* black] Gently seperate the two halves of the device, while taking care to not pull them too far apart, which could break the red wire that connects themdevice.
[* icon_caution] Make sure to take care in prying case apart. There is aare two wires (one red wireand one black) that could get disconnected from the motherboard.
[* black] Gently seperate the two halves of the device, while taking care to not pull them too far apart, which could break the red wire that connects themdevice.
[* red] To remove the circuit board from the right section of the device, unscrew the two 5.6 mm Phillips #00 screws.
[* black] When the screws have been fully unscrewed, use the tweezers to remove them from the device.