Conserte seus objetos Comunidade Loja

Alterações no passo nº 1

Edição por Liam Kandell —

Edição aprovada por Liam Kandell

Antes
Depois
Sem alteração

Linhas do passo

[title] Replace IC
-[* black] On the main PCB with the power-jack, replace the MTX2410 switchmode regulator IC (SO-8 Package).
+[* black] On the main PCB with the power jack, replace the MTX2410 switchmode regulator IC (SO-8 Package).
[* black] There is a pin-compatible device from Quorvo (ACT4060ASH-T) which has a different internal voltage reference but otherwise works fine. Only a resistor must be changed for this to work.
-[* icon_caution] Warning: I just encountered a problem with the ACT4060. It blew up on one lamp and damaged the LEDs as well. So it seem not a perfect replacement after all.
-[* black] Feedback Voltage for MXT2410 is 1.222V, for ACT4060 is 1.293V, so voltage divider on Pin5 must be changed accordingly.
+[* icon_caution] Warning: I just encountered a problem with the ACT4060. It blew up on one lamp and damaged the LEDs as well. So it seems not a perfect replacement after all.
+[* black] The feedback Voltage for MXT2410 is 1.222V, for ACT4060 is 1.293V, so voltage divider on Pin5 must be changed accordingly.
[* black] One can best adjust R4+R3 (series). Remove R4, measure R3 and R4, and increase. It should measure about 10.67kOhm (R3 plus R4), and it can be slightly increased to 11.51kOhm. So basically add 1kOhm to R3+R4.