Alterações no passo nº 2
Edição por Navy Vet 2015 —
Edição aprovada por Navy Vet 2015
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Drive PCB |
|---|---|
| + | [* red] Remove two PH1 screws |
| + | [* green] Gently pull up on the ribbon retaining tab. Do NOT pull on ribbon. It will slide itself out in final step |
| + | [* icon_note] Orange/Yellow steps only required if you need to remove the entire PCB |
| + | [* orange] Gently pull up on the ribbon retaining tab. Ribbon is attached to underside of PCB via a sticky pad. Gently pull the ribbon away from pad |
| + | [* yellow] Desolder both points. Red (Left) Black (Right) |
| + | [* black] Gently press up on the PCB where you removed the two PH1 screws and rotate the board upside down |
| + | [* icon_note] If your drive is "dead" this is where I would suggest replacing your electrolytic capacitors. There are 12 on the Thomson drive |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado