Skip to main content

Alterações no passo #5

Edição por Michael Bianchini

Edição aprovada by Michael Bianchini

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* red] Continue to remove the back by removing the 10ten 5.92mm T5 (5.92 mm) Torx screws located underneath the kickstand
[* orange] Remove the 7seven 5.87mm T5 Torx (5.87 mm) screws screws located under the camera casing.
[* yellow] Now you will be taking off the back plate from the main system. Begin loosening the back-plate with a spudgerplastic opening tool where gaps exist.
[* red] Continue to remove the back by removing the 10ten 5.92mm T5 (5.92 mm) Torx screws located underneath the kickstand
[* orange] Remove the 7seven 5.87mm T5 Torx (5.87 mm) screws screws located under the camera casing.
[* yellow] Now you will be taking off the back plate from the main system. Begin loosening the back-plate with a spudgerplastic opening tool where gaps exist.
[* icon_caution] There is an electrical ribbon connecting the back plate to the motherboard. Do not pull apart the back plate from the motherboard once you have loosen the back plate from the main system.
[* icon_note] Continue working your way around to each corner and loosen the snap-ons on each side until the back plate comes off