Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Loja

Alterações no passo #2

Edição por Arthur Shi

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração

Linhas de Passo

[* icon_note] Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to.
[* black] If your pre-cut adhesive has pull tabs facing the center hole, the adhesive will attach to the phone's battery well first.
[* black] If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first.
[* black] Peel the '''clear plastic liner''' off of the pre-cut adhesive strip, exposing the adhesive.
[* black] Line up a long edge of the adhesive with the proper surface, as determined above.
[* black] SetCarefully set the adhesive down lightly on the surface.
[* black] If iticon_note] The adhesive is not properly aligned,very sticky, so you can carefully peel the adhesive back up and realignhave only one chance to align it.
[* black] SetCarefully set the adhesive down lightly on the surface.
[* black] If iticon_note] The adhesive is not properly aligned,very sticky, so you can carefully peel the adhesive back up and realignhave only one chance to align it.