Alterações no passo #2
Edição por Arthur Shi —
Edição aprovada por Arthur Shi
- Antes
- Depois
- Sem alteração
Linhas de Passo
| [* icon_note] Before you begin, figure out how the pre-cut adhesive strip should be oriented and which surface to attach it to. |
| [* black] If your pre-cut adhesive has pull tabs |
| [* black] If your pre-cut adhesive has pull tabs |
| [* black] If your pre-cut adhesive strip has pull tabs on the outer perimeter, the adhesive will attach to the battery first. |
| [* black] Peel the '''clear plastic liner''' off of the pre-cut adhesive strip, exposing the adhesive. |
| [* black] Line up a long edge of the adhesive with the proper surface, as determined above. |
| [* black] Set the adhesive down lightly on the surface. |
| [* black] If it is not properly aligned, you can carefully peel the adhesive back up and realign it. |