Ir para o conteúdo principal

Alterações no passo #7

Edição por Adam O'Camb

Edição aprovada por Adam O'Camb

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Line up the rear camera bezel with the rear camera and flash cutouts on the rear glass, then set it down on the adhesive.
+[* black] Line up the rear camera bezel with the cutouts on the rear glass, then set it down on the adhesive.
[* black] Make sure the camera bezel is completely seated in the rear glass's camera cutout so that the bezel lays flat against the glass.
-[* black] Apply even pressure to the bezel for 30 seconds to make sure the adhesive bonds properly.
-[* black] When you are ready to install the rear glass, but before you seal the phone, peel off the black backing covering the camera glass.
+[* black] Use your fingers to apply even pressure to the bezel for 30 seconds to make sure the adhesive bonds properly.
+[* black] Immediately before you install the rear glass and seal the phone, peel off the black backing covering the camera glass.