Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Alterações no passo #5

Edição por Adam O'Camb

Edição aprovada de Adam O'Camb

Antes
Depois
Sem alteração

Linhas de Passo

[* black] Peel away the clear backing from the camera bezel adhesive strip, exposing the adhesive on one side.
[* black] Very carefully line up the rear camera and flash cutouts on inside of the rear glass with the same cutouts on the adhesive strip.
[* black] Set the adhesive strip on the rear glass and make sure it does not overlap the edges of the camera or flash cutouts at all.
[* black] Use your fingers or the flat edge of a spudger to press the adhesive down so that it bonds to the glass.
[* black] Peel the green backing away from the adhesive strip. Make sure the adhesive does not come off of the glass with the backing.
[* icon_note] If your part did not come with pre-cut adhesive, use high-bond double sided tape, such as [product|IF317-072|Tesa 61395|new_window=true], or pieces of a [guide|113604|pre-cut adhesive sheet|new_window=true] to secure the camera bezel.