Skip to main content

Alterações no passo #4

Edição por Andrew Bookholt

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Insert the flat end of a spudger between the front bezel and the plastic strip attached to the rear bezel near the screw holes at the bottom corners of the display.
[* black] Rotate your spudger toward the rear bezel to separate it from the front bezel.
[* black] If necessary, enlarge the gap between the lower edge of the rear bezel and the clutch cover until theythe two components are completely separated.
[* black] If necessary, enlarge the gap between the lower edge of the rear bezel and the clutch cover until theythe two components are completely separated.