Pular para o conteúdo principal

Alterações no passo #3

Edição por Andrew Optimus Goldheart

Edição aprovada por Andrew Optimus Goldheart

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.
[* black] RemoveCarefully place a suction cup halfway up the iOpener from the iPad.
[*
heated side.
[*
black] Place a suctionBe sure the cup is completely flat on the bottom right of the front panel glass, just above the lower bezel and near the right edge of the devicescreen to get a tight seal.
[* black] WithWhile holding the iPad down with one hand on the devicehand, pull up on the suction cup enough to open a small gap betweenslightly separate the front panel glass andfrom from the rear panelcase.
[* icon_caution] Be careful to only lift the glass enough to insert an opening pick—any more and you may risk cracking the glass
.

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Versão Antiga

Nova Versão

Imagem 3

Nenhuma imagem anterior

Adicionado