Ir para o conteúdo principal

Alterações no passo #3

Edição por Arthur Shi

Edição aprovada por Arthur Shi

Antes
Depois
Sem alteração

Linhas de Passo

-[* black] Insert wisdom here.
+[* black] Set the pre-cut adhesive strip next to the back panel so that it is properly oriented.
+[* icon_note] Optionally, you can tape the pre-cut adhesive strip into position for easier application.
+ [* black] Lay the pre-cut adhesive strip over the back panel, aligning it to the edges.
+ [* black] Tape one edge of the pre-cut adhesive strip to the back panel, locking the alignment in place while allowing the strip to still swing outward.