Pular para o conteúdo principal

Alterações no passo #4

Edição por Aaron Cooke

Edição recusada por Adam O'Camb

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Slide each RAM module straight out to remove it.
[* icon_caution] When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edgeedge, as the oils on your fingers may prevent the gold contact points from connecting properly.
[* icon_remindericon_note] To install a new RAM module, make sure it's oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle. Press evenly until it clicks into place and the gold contacts are no longer visible.
[*

[* icon_caution] Do not use brute force to put your RAM back into place! You risk breaking the RAM or breaking the RAM slot off the logic board.
[*
icon_reminder] If the RAM is not going in with moderate force, inspect the RAM slot for debris and make sure the "notch" is correctly aligned.
[* black]
Then, spread the clips apart with one hand, and with the other press to angle the top edge of both RAM modules down toward the logic board simultaneously.
[* icon_caution] When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edgeedge, as the oils on your fingers may prevent the gold contact points from connecting properly.
[* icon_remindericon_note] To install a new RAM module, make sure it's oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle. Press evenly until it clicks into place and the gold contacts are no longer visible.
[*

[* icon_caution] Do not use brute force to put your RAM back into place! You risk breaking the RAM or breaking the RAM slot off the logic board.
[*
icon_reminder] If the RAM is not going in with moderate force, inspect the RAM slot for debris and make sure the "notch" is correctly aligned.
[* black]
Then, spread the clips apart with one hand, and with the other press to angle the top edge of both RAM modules down toward the logic board simultaneously.
[* black] Release the clips and make sure the RAM modules are secure.