Pular para o conteúdo principal

Alterações no passo #4

Edição por Jeff Suovanen

Edição aprovada por Jeff Suovanen

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Slide each RAM module straight out to remove it.
[* icon_caution] When handling the RAM module, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.
[* icon_reminder] To install a new RAM module, make sure it's oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle and press evenlyangle. Press evenly until it clicks into placeplace and the gold contacts are no longer visible.
[* icon_reminder] To install a new RAM module, make sure it's oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle and press evenlyangle. Press evenly until it clicks into placeplace and the gold contacts are no longer visible.
[* icon_reminder] Then, spread the clips apart with one hand, and with the other press to angle the top edge of both RAM modules down toward the logic board simultaneously.
[* black] Release the clips and make sure the RAM modules are secure.