Pular para o conteúdo principal

Alterações neste passo

Edição por Sam Goldheart

Edição aprovada por Sam Goldheart

Excluído
Adicionado
Sem alteração

Linhas de Passo

[title] Remove fan screws
[* black] Unscrew the 4xUse a T6 Torx TR6 fandriver to remove the four 7.2 mm screws and lift outsecuring the fan:
[* red] Two screws securing
the fan assembly.
[* icon_caution] Careful,
to the logic board
[* orange] Two screws securing
the fan is still connected to the logicboard by a cableexhaust vent
[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened
.
[* black] Unscrew the 4xUse a T6 Torx TR6 fandriver to remove the four 7.2 mm screws and lift outsecuring the fan:
[* red] Two screws securing
the fan assembly.
[* icon_caution] Careful,
to the logic board
[* orange] Two screws securing
the fan is still connected to the logicboard by a cableexhaust vent
[* icon_note] Rubber grommets secure these screws to the fan, so they may not come out completely. Just make sure they are fully loosened
.

Imagem 1

Versão Antiga

Nova Versão

Imagem 2

Nenhuma imagem anterior

Adicionado