Alterações no passo #2

Edição por Carsten Dahl Hjarup

Edição aprovada por Carsten Dahl Hjarup

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] To fix the issue:
[* black] 1. Use compressed air (gently) to blow into the connector to remove loose debris. Alternatively use a straw and blow directly into the connector.
[* black] 2 . clean the connector with clean water and paper towel cut in tiny strip. Dispense water gently via drop directly into the connector, and remove them again with paper towel strips
[* black] 3. let it dry, by blowing with a hair dryer ontodry: leave the connector alone for 5 minutes. Or leave6hrs so it can dry out before charging. Using the pone in a warm place for min. 45 minutesthis time span is ok.
[* black] 3. let it dry, by blowing with a hair dryer ontodry: leave the connector alone for 5 minutes. Or leave6hrs so it can dry out before charging. Using the pone in a warm place for min. 45 minutesthis time span is ok.
[* black] If charging is needed urgently, use wireless charging (S9+)
[* black] Be aware that the charge cable connector can be contaminated with salt/ or rust. Therefore it need to be gently cleaned as described above . Else it can transfer to the phone, and cause the issue again. Or cause the issue while connected to the phone.