Alterações no passo nº 2
Edição por Marley Miller —
Edição aprovada por Marley Miller
- Antes
- Depois
- Sem alteração
Linhas do passo
| - | [* black] Grab two 3/16" Allen wrenches. Insert one in each screw on the sides of the wheel. Hold one screw in place while |
|---|---|
| + | [* black] Grab two 3/16" Allen wrenches. Insert one in each screw on the sides of the wheel. Hold one screw in place while turning the other in a counter-clockwise direction. This should loosen the screws. |
| [* black] Once both screws are removed the wheel should be free and fall out. | |
| - | [* icon_note] One of the screws encapsulates the other. The inner screw should be |
| - | [* icon_caution] |
| + | [* icon_note] One of the screws encapsulates the other. The inner screw should be 5.6 mm in length. During reassembly, the screws can be put back in on either side. |
| + | [* icon_caution] During reassembly, do not over-tighten the screws. They should be just firm enough to prevent the wheel from shaking (no free play). Over-tightening could result in stripped screws. |