Pular para o conteúdo principal

Alterações no passo #10

Edição por Anthony Fassler

Edição recusada por Adam O'Camb

Sem alteração

Linhas de Passo

[* black] Find a connector on the motherboard labeled '''HD TMP''' or '''HDD TEMP'''.
[* icon_note] If you have trouble locating it, trace the two-wire temperature cable you disconnected from the old hard drive.
[* black] If the previous temperature cable is still connected to the board here, disconnect and remove it. You will no longer need it.
[* black] Connect the temperature sensor's two-wire red-black cable to the motherboard plug labeled '''HD TMP''' or '''HDD TEMP'''.
[* icon_note] The connector is keyed to fit in one way only. If it seems like the connector is not fitting the socket, flip the connector and try again.
[* black] Route the excess wire so it does not interfere with any other components.
[* icon_note] After installing your SSD think to enable [guide|111570|TRIM] for better performance.