Pular para o conteúdo principal

Alterações no passo #10

Edição por Arthur Shi

Edição aprovada por Arthur Shi

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Trace the two-wire temperature cable you disconnected from the old hard drive. It should end at a socket on the motherboard labeled '''HDD TEMP'''.
[* black] If there is an existing two-wire cable in the socket, disconnect and remove the old temperature cable. You will no longer need it.
[* black] Connect the two-wire red-black temperature cable to the same motherboard connector.
[* icon_note] The connector is keyed to fit the socket in only one wayway only. If it seems like the connector is not fitting the socket, flip the connector and try again.
[* icon_note] The connector is keyed to fit the socket in only one wayway only. If it seems like the connector is not fitting the socket, flip the connector and try again.
[* black] Route the excess wire out of the way.
[* icon_reminder] This concludes the instructions specific to the SSD upgrade. Continue to follow the rest of the guide to reassemble your iMac.