Pular para o conteúdo principal

Alterações no passo #15

Edição por Jeroen Versteijnen

Edição aprovada por Jeff Suovanen

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* black] Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it once the pick is past the home button. When approaching the bottom left corner, beware of the home button ribbon cable and pull out the pick so its max depth is 1/2 inch in going around the corner.
[* black] Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it once the pick is past the home button. When approaching the bottom left corner, beware of the home button ribbon cable and pull out the pick so its max depth is 1/2 inch in going around the corner.
[* icon_note] If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.
[* icon_caution] Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.