Ir para o conteúdo principal

Alterações neste passo

Edição por Nick

Aguardando aprovação

Excluído
Adicionado
Sem alteração

Linhas de Passo

[* icon_caution] In this step, make sure to only disconnect the connector from its socket, and not the entire socket from the interconnect board.
[* black] Use the tip of a spudger to gently pry the hard drive thermal sensor connector away from its socket on the interconnect board. Make sure to only detach the connector and not the socket that is soldered to the interconnect board and will break easily,if it does,the fan that cools that section will run at full speed at all times wearing them out quicker and requires component level soldering
[* black] IMPORTANT NOTE: This is a new type of press-on connector: it does not slide on from the end like ordinary jumpers or PCB header connectors. When removing it, gently lift the connector UP away from the
board.
[* black] Use the tip of a spudger to gently pry the hard drive thermal sensor connector away from its socket on the interconnect board. Make sure to only detach the connector and not the socket that is soldered to the interconnect board and will break easily,if it does,the fan that cools that section will run at full speed at all times wearing them out quicker and requires component level soldering
[* black] IMPORTANT NOTE: This is a new type of press-on connector: it does not slide on from the end like ordinary jumpers or PCB header connectors. When removing it, gently lift the connector UP away from the
board.