Histórico do passo nº 10 do guia 1911A1 45 Cal Teardown

Alterações no passo nº 10

Edição por Wraithvenge — 29 de set de 2012

Edição aprovada por Wraithvenge

	[* black] Using a brass punch, slowly knock out the main housing spring pin.
-	[* icon_caution] Make sure the hammer is forward and not pulled back! The spring in the main housing provided pressure for the hammer. Your punch will be difficult to remove and the main housing can fly off when you pull the punch out.
-	[* black] Remove the main housing to reveil the Sear/Trigger/Grip Safety spring (This is a flat ~~tention~~ spring so no worries about parts flying everywhere). It will just fall out or shake it out (tweezers not needed, just used to show spring placment).
+	[* icon_caution] Make sure the hammer is forward and not pulled back! The spring in the main housing provided pressure for the hammer. Your punch will be difficult to remove and the main housing can fly off when you pull the punch out if the hammer is pulled back.
+	[* black] Remove the main housing to reveil the Sear/Trigger/Grip Safety spring (This is a flat leaf spring so no worries about parts flying everywhere). It will just fall out or shake it out (tweezers not needed, just used to show spring placment).