Ir para o conteúdo principal

Alterações no passo #12

Edição por Tarun Thiruma

Edição aprovada por Tarun Thiruma

Antes
Depois
Sem alteração

Linhas de Passo

[title] Pry Up the Screen Assembly
[* black] Slowly and carefully slide the flat end of a spudger under the left edge of the screen assembly. Gradually insert it deeper to pry up the top edge of the assembly and release the right patch of adhesive.
[* icon_note] Add more isopropyl alcohol as needed, but take care to not use too much, as this may dissolve other adhesives in the device that would preferably remain sticky. Give any additional alcohol some time to penetrate the adhesive before continuing.
- [* icon_caution] Only pry the assembly up enough to slide the spudger underneath and release the adhesive. The assembly is still attached via the display cable, and prying the left side too far upward may damage it.
+ [* icon_caution] Only pry up the assembly enough to slide the spudger underneath and release the adhesive. The assembly is still attached via the display cable, and prying the left side too far upward may damage it.