Alterações no passo nº 12
Edição por Tarun Thiruma —
Edição aprovada por Tarun Thiruma
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Pry Up the Screen Assembly |
|---|---|
| + | [* black] Slowly and carefully slide the flat end of a spudger under the left edge of the device. Gradually insert it deeper to pry up the top edge of the screen assembly and release the right patch of adhesive. |
| + | [* black] Reheat the adhesive to soften it as needed. |
| + | [* icon_note] Alternatively, you can [https://d3nevzfk7ii3be.cloudfront.net/igi/MRJHl2UN6phRCMcq.full|apply high concentration (>90%) isopropyl alcohol|new_window=true] underneath the screen assembly and wait ~5 minutes to allow it to penetrate and weaken the adhesive. |
| + | [* icon_caution] Only pry the assembly up enough to slide the spudger underneath and release the adhesive. The assembly is still attached via the display cable, and prying the left side too much may damage it. |
Imagem 1
Nenhuma imagem anterior
Adicionado
Imagem 2
Nenhuma imagem anterior
Adicionado
Imagem 3
Nenhuma imagem anterior
Adicionado