Alterações no passo nº 2
Edição por Tarun Thiruma —
Edição aprovada por Tarun Thiruma
- Antes
- Depois
- Sem alteração
Linhas do passo
| [title] Release the Screen Assembly | |
| - | [* black] Insert a jimmy or other metal tool between the |
| + | [* black] Insert a jimmy or other metal tool between the right side of the plastic display and the metal frame, near the phone's side buttons. |
| [* icon_note] This may require a considerable amount of force. Push the tool as far down into the gap as you can, taking care to not scratch the chassis of your device in the process. | |
| - | [* black] Tilt the jimmy downward while simultaneously continuing to push it deeper into the gap to pry up the side of the display assembly. |
| + | [* black] Tilt the jimmy downward while simultaneously continuing to push it deeper into the gap to pry up the right side of the display assembly. |
| [* icon_caution] As the display on top of the screen assembly is flexible and only attached with a slight amount of adhesive, you may end up only prying up the display from the screen assembly instead of lifting the entire assembly. If this occurs, remove the tool and try again, this time using more downward force to get underneath the entire assembly. | |
| [* icon_note] Ensure your tool is behind the entire screen assembly and not just the display. You should notice the thin silver metal midframe come up with the plastic display (as shown) if you have done this correctly. |