Alterações neste passo
Edição por Tarun Thiruma —
Edição aprovada por Tarun Thiruma
- Antes
- Depois
- Sem alteração
Linhas do passo
| + | [title] Heat the Screen Adhesive |
|---|---|
| [* icon_caution] Power your phone off before you begin. | |
| [* icon_note] If possible, drain the battery before disassembly. When the battery is charged, there's increased risk of a dangerous thermal event if the battery is overheated or damaged during repairs. | |
| [* black] [guide|25705|Prepare an iOpener|new_window=true] and heat the front of the phone along its bottom edge for about two minutes, or until it's slightly too hot to touch. This will help soften the adhesive securing the screen assembly. | |
| [* icon_note] You may need to reheat and reapply the iOpener several times to get the phone warm enough. Follow the iOpener instructions to avoid overheating. | |
| [* icon_caution] Since the display is made of plastic, it is especially susceptible to warping and display damage. If you notice the display bubbling up or wrinkling, stop heating immediately and cool down the device before trying again. | |
| [* icon_note] A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the device. |