Histórico do passo nº 5 do guia Acer E5-571-54FL Hard Drive Replacement

Alterações no passo nº 5

Edição por Dario DiMascio — 28 de fev de 2024

Edição aprovada por Dario DiMascio

-	[* red] ~~There are~~ two ~~3mm~~ Phillips screws holding the hard drive into the carriage. ~~One~~ on ~~either~~ side of the carriage.
+	[* red] Locate the two 3 mm Phillips screws holding the hard drive into the carriage. There is one screw on each side of the carriage.
	[* black] Hold the hard drive carriage with your non-dominant hand along one side. Ensure one of the Phillips screws is visible.
-	[* black] Using a #0 Phillips screwdriver, remove the ~~3mm~~ screw to release the side of the hard drive from the carriage.
-	[* black] Repeat the two previous ~~procedures~~ to remove the second ~~3mm~~ Phillips screw ~~freeing~~ the hard drive from the carriage.
+	[* black] Using a #0 Phillips screwdriver, remove the 3 mm screw to release the side of the hard drive from the carriage.
+	[* black] Repeat the two previous bullet marks to remove the second 3 mm Phillips screw. This should also free the hard drive from the carriage.